Hakko FR872-03 - 4-Bank IR PCB Preheater - 122-392°F - 14.2" x 3.8" x 21.1"

The Hakko FR872-03 4-Bank IR PCB Preheater has a low-profile bench top design and used to elevate the temperature of printed circuit board assemblies so that the components on them can be soldered and de-soldered more easily with improved results. It's useful on medium to high-mass boards, which can heat-sink a significant amount of energy being supplied by a soldering iron tip or hand-held hot air tool and lead-free assemblies. This pre-heater uses high efficiency carbon filament IR heating lamps and has 4 independently controlled heating zones that cover a total of 8.8" x 10.5" for a large effective heating area. The Hakko FR872-03 4-Bank IR PCB Preheater also features a manual and auto operation mode and a ramp control feature that controls the ramp rate of the PCB when using either of the thermocouple modes for temperature control. In the auto operation mode it follows a 3-heating zone profile that can be programmed into the system with up to 20 possible profiles. Along with that this preheater is controlled by power percentage or thermocouple for closed-loop feedback of the PCB heating, has soft EPO to protect assemblies, and has integration capabilities with the Hakko FR-803B hot air and FM-206 rework systems with the use of a connecting cable (sold separately please see accessories tab above).

Benefits & Features of the Hakko FR872-03 4-Bank IR PCB Preheater:

• High efficiency carbon filament IR heating lamp
• 4-independent switchable zones
• Effective heating area
• Manual or auto operation modes
• Preheat controlled by power percentage or thermocouple for closed-loop feedback of the PCB heating
• Ramp control controls the ramp rate of the PCB when using either of the thermocouple modes of temperature control
• Soft EPO to protect assemblies
• Automatic operation following a 3-heating zone profile that can be programmed into the system (with up to 20 possible profiles)
• Faster than ceramic IR heating
• Integration capability with the Hakko FR-803B hot air and FM-206 rework systems with connecting cable (not included)

Included with the Hakko FR872-03 4-Bank IR PCB Preheater:

• 1 - FR-872 4-Bank IR Preheater
• 1 - A5003 High efficiency carbon filament IR heater (spare)
• 1 - B3516 Thermocouple
• 1 - B5042 Power cord
• 1 - Instruction manual

4-Bank IR PCB Preheater - 122-392°F - 14.2" x 3.8" x 21.1"